My Cart: 0 item(s)
Powell Peralta Skateboards Ripper Patch - 10"
- 9.975” X 10"
- iron-on backing
Application
- Denim and cotton material provide the best base. Be careful of polyester.
- Put the item on a hard surface, like an ironing board. Iron it to create a nice, flat surface.
- Place the patch where you want it to be.
- Heat up the iron to it's hottest setting.
- Place a thin cloth over the patch. (This will protect the patch and any surrounding material).
- Place the iron over the patch and press down hard as possible for 15-30 seconds.
- Remove the iron and let patch cool.
- Check the patch by gently rubbing at the edge, trying to lift it. If it lifts, replace the thin material and iron again for 10- 15 seconds.
- To ensure a secure patch you can also sew around the edges.
No Reviews Yet!
Not Yet Rated!
